|
Post by darkside on Feb 3, 2019 19:25:35 GMT -5
I'm wondering if anyone has any bright ideas to use a double mold as one side only, with a flat back, that is still hollow... doable?
|
|
gap
Apprentice
Posts: 390
|
Post by gap on Feb 3, 2019 21:27:46 GMT -5
Yes, it is doable. How much time do you have on your side? :-)
You mould the half shape you want to use. Let it set and remove from mould. Then, on an acetate sheet, make a thin film of chocolate. Place your "moulded half shape" with the open side onto the film of chocolate. As the chocolate is almost set, cut around the shape. Once fully set, you will have your "moulded half shape" with a bottom on it and everything is hollow.
|
|
|
Post by Chip on Feb 10, 2019 17:28:22 GMT -5
I'm wondering if anyone has any bright ideas to use a double mold as one side only, with a flat back, that is still hollow... doable? Gap, you are right, that's a lot of work!!
|
|